![]() ![]() I faced similar issue when trying to apply same pattern for notifications, but the "All devices" flag let me skip the equivalent of C step. The instructions are provided during the initial setup, or can be. ![]() From your smartphone, open the Garmin Connect Mobile app, and follow the on-screen instructions to connect a device. Traccar is presenting a bug in the geofence, is that although the GPS reports in the geofence, traccar does not trigger the event enter geofence or exit geofence. From your device, select > Bluetooth > Enable > Pair Smartphone, and follow the on-screen instructions. If I don't set "device readonly" on users, A won't be possible, but B and C are satisfied Bring your smartphone within 10 m (33 ft.) of your device. If I use the set "device readonly" on users, A and B are satisfied but C won't be possible. New issue Add geofence to deviceStopped events and Stops Report 3969 Open delkant opened this issue on 0 comments delkant commented on deviceStopped event should have the geofenceId on the event table when this event is happening on a existing geofence. It is happening when I assign a geofence to a group, in some devices the event of enter geofence or exit geofence is not performed, I tried associating the devices directly to the. Too bad users want free and so I shutdown. It was not cost effective on my part but it was cheap for users. I started, ran, shutdown a system specific to this use case Simplex Locate. Specify the following : location of the guarded facility on the map geofence radius (from 150 m to 3000 m) Enable Geofence. Well there are as many 'hacks' and opinions to this subject as there are solutions. To enable geofence enter/exit notification for an admin or non-readonly user I have toġ- create geofence (settings > geofences)Ģ- associate geofence to my user or other user (settings > users > geofences)ģ- set device to send notification for that geofence (devices > select device > device settings > geofences)īut the general scenario is single admin user that creates users with lower permissions, then:Ī- users cannot add or remove devices (device readonly)Ĭ- users can select which geofence notifications receive for which devices Traccar is presenting a bug in the geofence, is that although the GPS reports in the geofence, traccar does not trigger the event enter geofence or exit geofence. Drag-and-drop hub location pin to specify the protected facility on the map.
0 Comments
Leave a Reply. |